November 18, 2026

How Intelligent Transportation Systems Improve Highway And Bridge Safety

How Intelligent Transportation Systems Improve Highway And Bridge Safety

Some commercial vehicles head onto the highway with a seized brake or a bearing running hot. Nothing looks wrong from the road. Nobody notices until something fails at full highway speed. Problems like these are exactly what intelligent transportation systems are built to catch early, long before a bad day turns into a crash report. So how does that actually work on real highways and bridges?

The Inspection Math Just Doesn't Add Up

An inspection station can only look at so many vehicles in a shift. Meanwhile, large and medium trucks and motor coaches keep rolling, and FMCSA data puts their travel at more than 300 billion miles every year. A manual check on each one is simply out of reach. Most vehicles pass unexamined, good or bad, because staff and hours run out long before traffic does. Brake problems have also been named as a contributing factor in more than a third of fatal large truck accidents, yet only a small fraction of vehicles can be examined closely.

For this reason, prescreening is considered an important part of inspection work. Vehicles are sorted by technology before any manual check, and only those showing signs of a problem are selected for a full inspection. Well-maintained vehicles are allowed to continue on their way, and the limited time of inspection teams is directed towards the vehicles that need attention.

Heat Tells The Truth

Thermal imaging does not care how a wheel looks. It reads how hot it actually is. Two infrared cameras scan each passing vehicle and cover both sides. Axle readings are then checked against rules taken from past inspections. That is how the Smart InfraRed Inspection System, or SIRIS, works, and the system was developed by International Electronic Machines Corporation (IEM). Any vehicle that falls outside those rules is reported to station staff, who decide whether it is pulled over.

The results are surprisingly readable. A brake that runs too hot is usually dragging. A brake that runs too cold may not be working at all. Thermal imaging is not limited to brakes. Overheated bearings show up on it, and so do underinflated tires, exposed steel belts, and partial tread delamination. For highway and bridge safety, this matters a great deal, because a bearing that seizes can change the way a truck handles or cost it a wheel altogether.

A wheel that comes loose at speed is a danger to every vehicle around it. Faults of this kind are best caught at an inspection site, where a vehicle can be stopped before it gets back on the road. Temperature readings, not appearance, decide which vehicles are stopped.

Keeping Up At Highway Speeds

A screening tool is only useful if it does not slow traffic down. High-Speed SIRIS is built for exactly that job. It runs automatically with no dedicated operator, evaluates the whole vehicle, and works at highway speeds. It can also be connected with wireless roadside inspection technology.

Good intelligent transportation systems also have to survive real weather. IEM's ITS equipment is designed to keep working in fog, snow, direct sunlight, heavy wind, and high heat. Not every inspection site is a tidy parking lot, after all.

Flexibility matters too. SIRIS comes in several setups:

  • A permanent fixed site at an inspection station
  • A portable unit for temporary inspection sites
  • A vehicle-mounted system for mobile enforcement
  • A handheld device for spot checks

The setup should be matched to the site instead of one design being used everywhere.

Bridges Tell A Different Story

A truck does not need to be defective to cause trouble there. An overweight load, a heavy impact, or a bad storm can all leave damage that nobody sees right away. Hidden damage is the kind nobody wants to discover late.

Scheduled inspections are still considered important but gaps are left between each visit. These gaps can be filled by continuous monitoring. Sensors and cameras can be used to report that an event has taken place, when it happened and how serious it might be. A crew can then be sent out while the facts are still fresh instead of weeks later.

The difference can be compared to a yearly checkup and a heart monitor. Both are found to be useful. Structures that matter most are better protected when routine inspections are paired with monitoring that continues day and night

Questions Worth Asking Before Buying

Anyone shopping for inspection technology can save a lot of back and forth by asking a few plain questions. Does the system need a dedicated operator watching a screen? Does it evaluate the whole vehicle or just one wheel at a time? Will it keep working in the weather the site actually gets? Can it connect with the roadside inspection tools already in place?

Answers like these separate systems that look good in a brochure from systems that hold up on a busy shoulder. Each takes about a minute to ask. The takeaway: write those questions into the evaluation checklist before any demo is scheduled.

Where This Goes Next

Safer roads rarely come from one big breakthrough. They come from catching small problems early, a hot brake here and a damaged span there. The catching of such problems is made faster by technology. Highway and bridge safety is treated as a matter of data by agencies that tend to stay ahead of the next failure. So which vehicles or structures in your network are still being checked by luck? The team at IEM is a good place to start asking.

  • rounded-right-arrow.svg

    Railway Solutions

  • rounded-right-arrow.svg

    Intelligent Transportation Systems

  • rounded-right-arrow.svg

    Intrusion Detection/Security Solutions

  • rounded-right-arrow.svg

    Remote Monitoring Solutions

  • rounded-right-arrow.svg

    Defense Solutions

  • rounded-right-arrow.svg

    Research and Development

  • rounded-right-arrow.svg

    Product Engineering

  • rounded-right-arrow.svg

    Software Development

  • rounded-right-arrow.svg

    Manufacturing

  • rounded-right-arrow.svg

    Sales and Marketing

  • rounded-right-arrow.svg

    System Installation

  • rounded-right-arrow.svg

    Post Installation Service

IEM Corporate Headquarters

International Electronic Machines Corporation